6f18ce8026
Add snapshot of device tree bindings from keystone common kernel, branch
"android-mainline-keystone-qcom-release" at c4c12103f9c0 ("Snap for 9228065
from e32903b9a63bb558df8b803b076619c53c16baad to
android-mainline-keystone-qcom-release").
Change-Id: I7682079615cbd9f29340a5c1f2a1d84ec441a1f1
Signed-off-by: Melody Olvera <quic_molvera@quicinc.com>
30 lines
988 B
Plaintext
30 lines
988 B
Plaintext
Altera Passive Serial SPI FPGA Manager
|
|
|
|
Altera FPGAs support a method of loading the bitstream over what is
|
|
referred to as "passive serial".
|
|
The passive serial link is not technically SPI, and might require extra
|
|
circuits in order to play nicely with other SPI slaves on the same bus.
|
|
|
|
See https://www.altera.com/literature/hb/cyc/cyc_c51013.pdf
|
|
|
|
Required properties:
|
|
- compatible: Must be one of the following:
|
|
"altr,fpga-passive-serial",
|
|
"altr,fpga-arria10-passive-serial"
|
|
- reg: SPI chip select of the FPGA
|
|
- nconfig-gpios: config pin (referred to as nCONFIG in the manual)
|
|
- nstat-gpios: status pin (referred to as nSTATUS in the manual)
|
|
|
|
Optional properties:
|
|
- confd-gpios: confd pin (referred to as CONF_DONE in the manual)
|
|
|
|
Example:
|
|
fpga: fpga@0 {
|
|
compatible = "altr,fpga-passive-serial";
|
|
spi-max-frequency = <20000000>;
|
|
reg = <0>;
|
|
nconfig-gpios = <&gpio4 9 GPIO_ACTIVE_LOW>;
|
|
nstat-gpios = <&gpio4 11 GPIO_ACTIVE_LOW>;
|
|
confd-gpios = <&gpio4 12 GPIO_ACTIVE_LOW>;
|
|
};
|