dbe8ff2b61
This change adds a new third cooling device node to support BW mitigation request and updates existing cooling device node name in dtsi to remove qcom, prefix so it is considered as single node and not two due to comma separated while parsing it in csv format. Change-Id: I341a2412159d2af6123a3bc4f2323a38b7955b62
209 lines
6.0 KiB
Plaintext
209 lines
6.0 KiB
Plaintext
// SPDX-License-Identifier: BSD-3-Clause
|
|
|
|
/*
|
|
* Copyright (c) 2024-2025 Qualcomm Innovation Center, Inc. All rights reserved.
|
|
*/
|
|
|
|
#include <dt-bindings/interrupt-controller/arm-gic.h>
|
|
#include <dt-bindings/interconnect/qcom,tuna.h>
|
|
|
|
&tlmm {
|
|
icnss_sw_ctrl: icnss_sw_ctrl {
|
|
mux {
|
|
pins = "gpio80";
|
|
function = "wcn_sw_ctrl";
|
|
};
|
|
};
|
|
};
|
|
|
|
&soc {
|
|
qcom,smp2p-wpss {
|
|
smp2p_wlan_1_in: qcom,smp2p-wlan-1-in {
|
|
qcom,entry-name = "wlan";
|
|
interrupt-controller;
|
|
#interrupt-cells = <2>;
|
|
};
|
|
|
|
smp2p_wlan_1_out: qcom,smp2p-wlan-1-out {
|
|
qcom,entry-name = "wlan";
|
|
#qcom,smem-state-cells = <1>;
|
|
};
|
|
|
|
smp2p_wlan_2_in: qcom,smp2p-wlan-2-in {
|
|
qcom,entry-name = "wlan_soc_wake";
|
|
interrupt-controller;
|
|
#interrupt-cells = <2>;
|
|
};
|
|
|
|
smp2p_wlan_2_out: qcom,smp2p-wlan-2-out {
|
|
qcom,entry-name = "wlan_soc_wake";
|
|
#qcom,smem-state-cells = <1>;
|
|
};
|
|
|
|
smp2p_wlan_3_out: qcom,smp2p-wlan-3-out {
|
|
qcom,entry-name = "wlan_ep_power_save";
|
|
#qcom,smem-state-cells = <1>;
|
|
};
|
|
};
|
|
|
|
icnss2_direct_link_iommu_group0: icnss2_direct_link_iommu_group0 {
|
|
qcom,iommu-dma-addr-pool = <0xb0000000 0x10000000>;
|
|
qcom,iommu-geometry = <0xb0000000 0x10010000>;
|
|
qcom,iommu-dma = "fastmap";
|
|
qcom,iommu-faults = "stall-disable", "HUPCF", "non-fatal";
|
|
};
|
|
|
|
icnss2: qcom,wcn7750 {
|
|
compatible = "qcom,wcn7750";
|
|
reg = <0x17110040 0x0>,
|
|
<0xc0000000 0x10000>;
|
|
reg-names = "msi_addr", "smmu_iova_ipa";
|
|
qcom,rproc-handle = <&wpss_pas>;
|
|
iommus = <&apps_smmu 0x1400 0x1>;
|
|
wlan-en-gpio =<35>;
|
|
host-sol-gpio =<132>;
|
|
dev-sol-gpio =<32>;
|
|
sw-ctrl-gpio =<80>;
|
|
/* List of GPIOs to be setup for interrupt wakeup capable */
|
|
mpm_wake_set_gpios = <80>;
|
|
pinctrl-names = "sw_ctrl";
|
|
pinctrl-0 = <&icnss_sw_ctrl>;
|
|
|
|
interrupts = <GIC_SPI 768 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 769 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 770 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 771 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 772 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 773 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 774 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 775 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 776 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 777 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 778 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 779 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 780 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 781 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 782 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 783 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 784 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 785 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 786 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 787 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 788 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 789 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 790 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 791 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 792 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 793 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 794 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 795 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 796 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 797 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 798 IRQ_TYPE_EDGE_RISING>,
|
|
<GIC_SPI 799 IRQ_TYPE_EDGE_RISING>;
|
|
|
|
qcom,iommu-group = <&icnss2_direct_link_iommu_group0>;
|
|
dma-coherent;
|
|
pin-ctrl-support;
|
|
qcom,fw-prefix;
|
|
qcom,wlan;
|
|
tsens = "sys-therm-3";
|
|
wcn-hw-version = "wcn7750";
|
|
qcom,wlan-msa-fixed-region = <&wlan_msa_mem>;
|
|
|
|
vdd-cx-mx-supply = <&S3B>;
|
|
qcom,vdd-cx-mx-config = <864000 1040000 0 0 0>;
|
|
vdd-1.8-xo-supply = <&S1B>;
|
|
qcom,vdd-1.8-xo-config = <1840000 2104000 0 0 0>;
|
|
vdd-1.3-rfa-supply = <&S2B>;
|
|
qcom,vdd-1.3-rfa-config = <1240000 1408000 0 0 0>;
|
|
vdd-1.8-io-supply = <&L3G>;
|
|
qcom,vdd-1.8-io-config = <1800000 1800000 0 0 0>;
|
|
vdd-1.2-io-supply = <&L2G>;
|
|
qcom,vdd-1.2-io-config = <1200000 1200000 0 0 0>;
|
|
|
|
qcom,smem-states = <&smp2p_wlan_1_out 0>,
|
|
<&smp2p_wlan_2_out 0>,
|
|
<&smp2p_wlan_3_out 0>;
|
|
qcom,smem-state-names = "wlan-smp2p-out",
|
|
"wlan-soc-wake-smp2p-out",
|
|
"wlan-ep-powersave-smp2p-out";
|
|
|
|
qcom,qmp = <&aoss_qmp>;
|
|
qcom,vreg_ol_cpr ="s3b";
|
|
|
|
interconnects =
|
|
<&pcie_noc MASTER_PCIE_0 &pcie_noc SLAVE_ANOC_PCIE_GEM_NOC>,
|
|
<&gem_noc MASTER_ANOC_PCIE_GEM_NOC &mc_virt SLAVE_EBI1>;
|
|
interconnect-names = "pcie_to_memnoc", "memnoc_to_ddr";
|
|
|
|
qcom,icc-path-count = <2>;
|
|
qcom,bus-bw-cfg-count = <9>;
|
|
qcom,bus-bw-cfg =
|
|
/** ICC Path 1 **/
|
|
<0 0>, /* no vote */
|
|
/* idle: 0-18 Mbps snoc/anoc: 100 Mhz */
|
|
<2250 400000>,
|
|
/* low: 18-60 Mbps snoc/anoc: 100 Mhz */
|
|
<7500 400000>,
|
|
/* medium: 60-240 Mbps snoc/anoc: 100 Mhz */
|
|
<30000 400000>,
|
|
/* high: 240-1200 Mbps snoc/anoc: 100 Mhz */
|
|
<100000 400000>,
|
|
/* very high: > 1200 Mbps snoc/anoc: 200 Mhz */
|
|
<175000 800000>,
|
|
/* ultra high: DBS mode snoc/anoc: 200 Mhz */
|
|
<312500 800000>,
|
|
/* super high: DBS mode snoc/anoc: 403 Mhz */
|
|
<587500 1612000>,
|
|
/* low (latency critical): 18-60 Mbps snoc/anoc: 200 Mhz */
|
|
<7500 800000>,
|
|
|
|
/** ICC Path 2 **/
|
|
<0 0>,
|
|
/* idle: 0-18 Mbps ddr: 547 MHz */
|
|
<2250 2188800>,
|
|
/* low: 18-60 Mbps ddr: 547 MHz */
|
|
<7500 2188800>,
|
|
/* medium: 60-240 Mbps ddr: 547 MHz */
|
|
<30000 2188800>,
|
|
/* high: 240-1200 Mbps ddr: 547 MHz */
|
|
<100000 2188800>,
|
|
/* very high: > 1200 Mbps ddr: 1555 MHz */
|
|
<175000 6220800>,
|
|
/* ultra high: DBS mode ddr: 2092 MHz */
|
|
<312500 8371200>,
|
|
/* super high: DBS mode ddr: 3.2 GHz */
|
|
<587500 14745600>,
|
|
/* low (latency critical): 18-60 Mbps ddr: 2092 MHz */
|
|
<7500 8371200>;
|
|
|
|
icnss_cdev_apss: icnss_cdev1 {
|
|
#cooling-cells = <2>;
|
|
};
|
|
|
|
icnss_cdev_wpss: icnss_cdev2 {
|
|
#cooling-cells = <2>;
|
|
};
|
|
|
|
qcom,smp2p_map_wlan_1_in {
|
|
interrupts-extended = <&smp2p_wlan_1_in 0 0>,
|
|
<&smp2p_wlan_1_in 1 0>;
|
|
interrupt-names = "qcom,smp2p-force-fatal-error",
|
|
"qcom,smp2p-early-crash-ind";
|
|
};
|
|
|
|
qcom,smp2p_map_wlan_2_in {
|
|
interrupts-extended = <&smp2p_wlan_2_in 0 0>;
|
|
interrupt-names = "qcom,smp2p-soc-wake-ack";
|
|
};
|
|
};
|
|
|
|
wlan_direct_link: qcom,icnss-direct-link {
|
|
compatible = "qcom,icnss-direct-link";
|
|
iommus = <&apps_smmu 0x100f 0x0>;
|
|
qcom,iommu-group = <&icnss2_direct_link_iommu_group0>;
|
|
dma-coherent;
|
|
};
|
|
};
|