ARM: dts: qcom: add PMIC PM8550VE_F and its peripherals for Sun boards

Add a PMIC PM8550VE_F device along with its peripheral device
subnodes.  This PMIC is found on Sun boards that use the V8
power grid instead of PMIC PM8550VS_F.

Change-Id: Idf4de30a6ceb891f563341bad0e0da21dca38b69
Signed-off-by: David Collins <quic_collinsd@quicinc.com>

qcom/pm8550ve.dtsi

@@ -36,6 +36,30 @@
 		};
 	};
 
+	pm8550ve_f: qcom,pm8550ve@5 {
+		compatible = "qcom,spmi-pmic";
+		reg = <0x5 SPMI_USID>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+		status = "disabled";
+
+		pm8550ve_f_tz: pm8550ve-f-temp-alarm@a00 {
+			compatible = "qcom,spmi-temp-alarm";
+			reg = <0xa00>;
+			interrupts = <0x5 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
+			#thermal-sensor-cells = <0>;
+		};
+
+		pm8550ve_f_gpios: pinctrl@8800 {
+			compatible = "qcom,pm8550ve-gpio";
+			reg = <0x8800>;
+			gpio-controller;
+			#gpio-cells = <2>;
+			interrupt-controller;
+			#interrupt-cells = <2>;
+		};
+	};
+
 	pm8550ve_g: qcom,pm8550ve@6 {
 		compatible = "qcom,spmi-pmic";
 		reg = <0x6 SPMI_USID>;
@@ -114,6 +138,34 @@
 		};
 	};
 
+	pm8550ve_f_temp_alarm: pm8550ve_f_tz {
+		polling-delay-passive = <100>;
+		polling-delay = <0>;
+		thermal-governor = "step_wise";
+		thermal-sensors = <&pm8550ve_f_tz>;
+		status = "disabled";
+
+		trips {
+			pm8550ve_f_trip0: trip0 {
+				temperature = <95000>;
+				hysteresis = <0>;
+				type = "passive";
+			};
+
+			pm8550ve_f_trip1: trip1 {
+				temperature = <115000>;
+				hysteresis = <0>;
+				type = "passive";
+			};
+
+			pm8550ve_f_trip2: trip2 {
+				temperature = <145000>;
+				hysteresis = <0>;
+				type = "critical";
+			};
+		};
+	};
+
 	pm8550ve_g_temp_alarm: pm8550ve_g_tz {
 		polling-delay-passive = <100>;
 		polling-delay = <0>;